Pack of 3 Sheets 8.5"x11" Clear Super Sticky Double Sided Adhesive 3M 300LSE
9495LEfor Cell Phone Repair & Multipurpose Use
Applications:Battery Bonding, Battery Door Attachment, Bezel Bonding, Camera
Module Assembly, Case Assembly, Cover Lens Bonding, Display Bonding, Electrical
Insulation Bonding, Electronic Component Bonding, Logo Bonding, Low Surface
Energy Bonding, Memory Card Bonding, Module Bonding to PET Card, Rubber Feet
Bonding, Speaker Module Assembly, Touch Panel Bonding, Touchpad Assembly,
Touchpad Bracket Assembly
Specifications:Color: ClearOperating Temperature Range (Celsius): 93 - 149
Degrees CTotal Tape Thickness without Liner: 0.17 mm (6.7 mil)Substrates:
Glass, HSE Plastics, LSE Plastics, Metals
Application Techniques:Bond strength is dependent upon the amount of
adhesive-to-surface contact developed. Firm application pressure and moderate
heat, from 100°F (38°C) to 130°F (54°C), will assist the adhesive in developing
intimate contact with the bonding surface. To obtain optimum adhesion, the
bonding surfaces must be clean, dry and well unified. Some typical surface
cleaning solvents are isopropyl alcohol or heptane.* Ideal tape application
temperature range is 70°F to 100°F (21°C to 38°C). Initial tape application to
surfaces at temperatures below 50°F (10°C) is not recommended because the
adhesive becomes too firm to adhere readily. However, once properly applied,
low temperature holding is generally satisfactory.
Environmental Performance:Humidity Resistance: High humidity has minimal
effect on adhesive performance. No significant reduction in bond strength is
observed after exposure for seven days at 90°F (32°C) and 90% relative
humidity. UV Resistance: When properly applied, nameplates and decorative trim
parts are not adversely affected by exposure to direct sunlight. Water
Resistance: Immersion in water has no appreciable effect on the bond strength.
After 100 hours at room temperature, the high bond strength is maintained.
Temperature Cycling Resistance: High bond strength is maintained after cycling
four times through: 4 hours at 158°F (70°C) 4 hours at -20°F (-29°C) 4 hours at
73°F (22°C) Chemical Resistance: When properly applied, nameplate and
decorative trim parts will hold securely after exposure to numerous chemicals
including oil, mild acids and alkalis.